China factory Xk-160 CZPT Open Mixing Mill for Rubber Use wholesaler

Item Description

Utilization

They are utilized to mix Rubber-, Silicone-, Abrasives, and PVC compounds.

Particularly in rubber-processing, mills are developed for diverse mixing processes.

Construct Up of Two Roll Mill

A mill is typically assembled on a steel foundation plate, which is once again established on rubber-pads or sound-metals adjustable, to isolate sounds-ranges to the constructing also to stay away from tensions on the mill structure, specifically levelling out of the mill is very essential for sleek operation.

 

 

Assortment accessible :

  

ProjectModel

SK400×1000

SK450×1200

SK560×1830

SK610×2030

SK660×2300

SK760×2800

Roll diameter(mm)

400

450

560

610

660

760

Doing work length(mm)

1000

1200

1830

2030

2300

2800

Major motor electrical power(kw)

forty five

fifty five

75

90

132

220

Reducer pace box

Tough toothed

Type of push

Cardan shaft

 

 
Rolls: 
Produced from chilled solid iron, within rolls are cooled by drinking water or 
heated by steam

Frames: 
Manufactured from welded steel plates or high tensile solid iron for maximum 
rigidity

Mattress: 
A single piece design of welded metal plate or cast iron provides maximum 
security

Bushing:
one) An oil sealed kind bushing, the bushing housing is manufactured from 
solid iron, and the inside diameter is fitted with high direct bronze. 
Made with h2o circulation circuit for water cooling, minimizing heat 
created in between the roll neck and the bushing

2) The bearing variety bushing is constructed of cast iron housing and high 
strength bearing at inside of diameter

Bushing lubrication:
Employs automatic circulated lubrication system

Roll hole adjustment:
one) Guide gap adjustment is standard
2) Run hole adjustment is optional

Reduction equipment box:
A few-stage totally enclosed equipment reducer is pushed by bevel equipment. Gears are 
lubricated by self splash lubrications system

The tooth surface hardness, it is divided into delicate tooth surface equipment transmission and difficult tooth surface area gear transmission. When the tooth area hardness of the two wheels (or a single of them) is less than or equivalent to 350HBW, it is called delicate tooth surface area transmission when the tooth surface hardness of the two wheels is >350HBW, it is known as hard tooth floor transmission. Comfortable-tooth surface area gear transmission is typically used for general low-pace gear transmission that does not need substantial precision, and tough-toothed floor equipment transmission is often employed for gear transmission that requires powerful bearing capability and compact framework.
Gears are utilised in a large variety of mechanical devices. Most importantly, they provide gear reduction for motorized products. This is important because usually little motors that spin really rapidly can provide sufficient energy to the gadget, but not sufficient torque, the pressure that brings about an item to spin or twist on an axis. For example, an electrical screwdriver has a really massive gear reduction (lowers the velocity of a rotating device (like an electric powered motor)) due to the fact it calls for a good deal of torque to switch the screw. But the motor makes only a modest volume of torque at substantial speeds. With gear reduction, the output speed can be reduced while rising the torque.

China factory Xk-160 CZPT Open Mixing Mill for Rubber Use     wholesaler